Toulon Wooden Sleigh Bed

1. Place the Centre Rail (13) on a flat surface.
2. Align each Support Leg (14) with the pre-drilled holes underneath the rail.
3. Insert Bolts with Flat Washers and Spring Washers through the holes into each leg.
4. Tighten all bolts securely using the Allen Key (J).

Note: If assembling the Super King size, assemble two Centre Rails instead of one.

1. Attach the Footboard Leg - LH (6) to the Footboard Foot - LH (8) using two Bolts (K).
2. Attach the Footboard Leg - RH (7) to the Footboard Foot - RH (9) in the same way.
3. Then, attach the Headboard Leg - LH (2) to one Headboard Foot (4) using two Bolts (K).
4. Repeat for the Headboard Leg - RH (3) and the remaining Headboard Foot (4).

1. Position the Headboard Legs (2, 3) and Footboard Legs (6, 7) upright.
2. Connect the Side Rails (10, 11) between the legs by aligning the bolt holes.
3. Insert two Bolts (B) through each connection point.
4. On the inside, place a Bracket (F), then a Flat Washer (D), Spring Washer (E), and Nut (C) onto each bolt.
5. Tighten all nuts using the Spanner (G) to secure the frame.

1. With the legs and feet already assembled, insert two Screws (I) into each leg from the inside.
2. Tighten the screws to reinforce the connection between the Legs and Feet.
3. Repeat for all four legs to ensure stability.

1. Position the Headboard (1) and Footboard (5) between the corresponding Side Rails.
2. Align the holes and insert Bolts (A) with the Allen Key (J) to secure each corner — 4 bolts per end.
3. Make sure the Headboard Legs (2, 3) and Footboard Legs (6, 7) are flush with the panels.
4. Insert Dowels (L) into the holes between the panels and legs for additional alignment.
5. Fully tighten all bolts using the Allen Key (J).

1. Position the Slat Support Rails (12) along the inside edges of the Side Rails (10, 11) and secure them using Bolts (H).
2. Place the Centre Rails (13) between the Headboard and Footboard, aligning them with the support legs.
3. Tighten all bolts with the Allen Key (J).
4. Insert Wooden Covers (M) into the visible bolt holes for a clean finish.

Note: If assembling the Super King size, repeat this step for both centre support rails.

1. Attach Single Plastic Caps (16) to the ends of the Bentwood Slats (15) that will connect to the Side Rails (10 & 11).
2. Attach Double Plastic Caps (17) to the slats that will connect to the Centre Rails (13).
3. Insert each end of the slats into the slots on the Side Rails and Centre Rails.
4. Press down firmly until all slats click securely into place.

Number of slats and caps per size:

• Double: 24 Bentwood Slats / 24 Single Caps / 12 Double Caps
• King: 26 Bentwood Slats / 26 Single Caps / 13 Double Caps
• Super King: 39 Bentwood Slats / 26 Single Caps / 26 Double Caps

• Verify that all slats are securely fastened and evenly spaced.
• Check for any loose connections and tighten the screws if necessary