Matilda Rattan Bed Frame

1. Align the Side Rail – RH (5) with the Footboard (3) as shown in the diagram.
2. Place the bracket on the corner of the Side Rail – RH (5) and the Footboard (3).
3. Secure the connection by inserting Bolt (C) through the bracket holes and into the Side Rail – RH (5) and Footboard (3).
4. Tighten the bolt using the Allen Wrench (G) to ensure a firm connection.

1. Align the Side Rail – LH (4) with the Footboard (3) as shown in the diagram.
2. Place the bracket on the corner of the Side Rail – LH (4) and the Footboard (3).
3. Secure the connection by inserting Bolt (C) through the bracket holes and into the Side Rail – LH (4) and Footboard (3).
4. Tighten the bolt using the Allen Wrench (G) to ensure a firm connection.

1. Lay the Headboard (1) face down on a soft, clean surface to protect the rattan.
2. Take each Foot (2) and align it with the threaded insert at the bottom of the headboard.
3. Carefully screw the leg into the headboard by rotating it clockwise until fully tightened.
4. Ensure both legs are straight and securely fitted.

1. Align the Side Rail – LH (4) and Side Rail – RH (5) with the Headboard (1) as shown in the diagram.
2. Insert Nut (A) into the designated holes on the Side Rails (4 & 5).
3. Position the Side Rails (4 & 5) against the Headboard (1) and align the holes.
4. Secure the connection by inserting Bolt (B) through Flat Washer (F) and into the aligned holes on the Headboard (1) and Side Rails (4 & 5).
5. Tighten the bolts using the Allen Wrench (G) to ensure a firm connection.

1. Place the Centre Rail (6) face down on a soft surface.
2. Align the Centre Rail Support Legs (7) with the pre-drilled holes along the rail.
3. Attach each leg by inserting a Bolt (E) through a Flat Washer (F) and securing it into the top of the leg, as shown in the diagram.
4. Use the Allen Wrench (G) to tighten each bolt firmly.

1. Place the assembled Centre Rail (6) inside the bed frame, positioning it between the headboard (1) and footboard (3).
2. Align both ends of the rail with the central mounting brackets attached to the inner sides of the footboard and headboard.
3. Secure the rail using Bolt (D) and Flat Washer (F) through the bracket holes, as shown in the upper-right detail. Tighten using the Allen Wrench (G).
4. Ensure both Support Legs (7) touch the ground. If necessary, adjust the height by rotating the feet at the base of each leg for firm contact with the floor.

Note: Make certain the bed is squared up as shown in the diagram then tigthen all bed assembly bolts 100%.

For Double Bed (Slats 9 & 10):

1. Position the Double Bentwood Slats (9 & 10) evenly across the bed frame.
2. Align the holes on each end of the slats with the pre-installed dowels on the inner edge of the Side Rails (4 & 5).
3. Insert the slats by pressing the holes over the dowels until securely in place.

For King Bed (Slats 8):

1. Place the two sets of King Bentwood Slats (8) evenly along the length of the frame.
2. Align the holes on each slat with the preassembled dowels in the Side Rails (4 & 5).
3. Press each slat down firmly so that it fits snugly over the dowels.

• Verify that all slats are securely placed and evenly spaced.
• Check for any loose connections and tighten the screws if necessary