Bordeaux Oak Wooden Sleigh Bed

1. Lay the Headboard Panel (A) face down on a soft surface to avoid scratches.
2. Align the Headboard Wood Legs (C) with the bottom edges of the panel. Use Wood Dowels (R) in the pre-drilled holes for extra stability.
3. Secure each leg using Bolt 45mm (L) and tighten with the Allen Key (Q).
4. Position the Bottom Stretcher (E) between the legs, just below the panel.
5. Fix it in place using additional Bolt 45mm (L) and Chipboard Screws Ø4x15 mm (O).
6. Reinforce with a Bracket (P) at the center joint if indicated

1. Attach the Headboard Aprons (F) to the side of the Headboard Panel (A).
2. Use Wood Dowels (R) in the alignment holes.
   Insert Bolt 45 mm (L) through the apron and into the headboard and tighten using the Allen Key (Q).
3. Repeat on both sides to secure both aprons symmetrically.
4. Insert Wood Buttons (K) into the bolt holes on the headboard legs and aprons for a clean finish.

1. Lay the Footboard Panel (B) face down on a protected surface.
2. Position the Footboard Wood Legs (D) on each end of the panel.
3. Insert Wood Dowels (R) into the pre-drilled holes for proper alignment.
4. Use Bolt 45 mm (L) to secure the legs through the designated holes and tighten the bolts with the Allen Key (Q).

1. Align the Footboard Aprons (G) with the inside edges of the Footboard Panel (B).
2. Insert Wood Dowels (R) into the pre-drilled holes.
3. Position each apron and secure with Bolt 45 mm (L) and tighten using the Allen Key (Q).
4. Insert Wood Buttons (K) into all visible bolt holes for a clean and finished appearance.

1. Stand the headboard and footboard upright, ensuring they are stable.
2. Align the Wood Side Rails (H) with the pre-installed brackets on both the headboard and footboard.
3. Secure each rail using Bolt 15 mm (M) with the Allen Key (Q).
4. Reinforce the side rail connection by inserting Chipboard Screws (O) through the metal plates located on the inside of the side rails.

1. Place the Center Bar (I) lengthwise between the side rails.
2. Ensure the bar is properly seated on the center support brackets attached to the side rails.

Number of Center Bar per size:

• Double and King: 1 Center Bar
• Super King: 2 Center Bars

1. Evenly space the Wooden Slats (J) across the frame, resting them on the side rails and center support bar(s).
2. Ensure each slat aligns with the pre-drilled holes on the support rails.
3. Secure each slat using Chipboard Screws (N).
4. Use a screwdriver or drill for faster installation, but avoid overtightening.

• Verify that all slats are securely fastened and evenly spaced.
• Check for any loose connections and tighten the screws if necessary